Professional device fts datasheet
Related Articles
- FTe installation guide for heavy duties
- FCPlus Getting started
- FCPlus FAQ
- Reports management
- Autolog settings
FTs datasheet
Original Product name: Ruptela Trace5-LTE-EMEA The Fleet Tracker FTs enables high-accuracy vehicle tracking, driver behavior monitoring, i/o sensors and capable of supporting specialized sensors and driver ID.
The Fleet Tracker FTs includes hardware and wire harness, shipping, professional installation included (connecting constant power, ignition power and ground).
FTs Wire harness includes buzzer, 6-pin connector for RFID reader and 2-pin connector for immobilizer.
Environmental specifications
| Temperature | Operating: | -30 to +60 °C |
| Storage: | -40 to +65 °C | |
| Battery charging: | 0 to +45 °C | |
| Battery discharging/storage: | -20 to +60 °C |
| Relative humidity | 5% to 95% Non-condensing |
Electrical specifications
| Power supply range | 8 - 30 V DC |
| Internal battery | LiPo 3.7 V 190 mAh (~1 hour of operation) |
| Protections | Battery short circuit protection Reverse polarity protection Electrostatic discharge protection on USB Charaing protection |
Average power consumption @ 12 V DC
Operating
| Idle mode (battery fully charged): | 33 mA* |
| Active mode (peak): | ~230 MA |
| Sleep mode (lowest): | ~3.5 mA |
| * - configuration dependent value |
Cellular
| Modem: | Fibocom MC610-EU |
| Antenna: | Internal |
| Bands (LTE-FDD): | B1/3/7/8/20/28 |
| Bands (GSM): | 900/1800 MHz |
| (GPRS multi-slot class 12) |
GNSS module
| Module: | U-blox M8 or M10 |
| Antenna: | Internal |
| Positioning systems: | GPS, GLONASS, Galileo |
| Augmentation systems: | QZSS, SBAS (WAAS, GAGAN, EGNOS, MSAS) |
| Aided start services: | AssistNow Online (A-GPS) |
| Tracking sensitivity: | -154 to -164 dBm |
| Reacquisition sensitivity: | -152 to - 160 dBm |
| Cold start duration: | < 30 s |
| Aided start: | As low as 3 s |
| Navigation update rate: | 10 Hz |
| Horizontal position accuracv: | 2.5 m (CEP, 50%, 24 hours static, -130 dBm, > 6 SVs) |
Interface
| 4 x Digital inputs (2 invertible) | Voltage range: | 0 - 30 V DC |
| Voltage threshold: | 4 V DC | |
| Voltage threshold when inverted: | 250 mV DC | |
| 2 × Analog inputs | Voltage range: | 0 - 30 V DC |
| Resolution: | 12 bit | |
| 2 × Digital outputs | Maximum voltage: | 32 V DC |
| Maximum current: | 1 A | |
| 1-Wire interface | Power output: | O MA @ 4.87 V DC |
| Power output: | 100 mA @ 4.65 V DC | |
| Maximum cable capacitance: | 4 nF | |
| User interfaces | Mini USB interface | |
| Indication LED | ||
| SIM card | Nano SIM (4FF) | |
| Accelerometer | Built-in 3-axis (GreenDriving, motion sensing, g-force up to 4 g) | |
| Internal storage | 8MB |
Certifications
| Certifications | CE |
| E-Mark | |
| CITC (pending) |
Physical properties
| Dimensions | 65 × 61 × 22 mm |
| Weight | 70 g |
| Housing | Plastic (PC + ABS) |
Standard Configuration
| Min. Period: | 60 seconds |
| Min.Distance: | 1000 meters |
| Min.Angle: | 10 degrees of direction change |
| HeartBeat: | 1 hour |
| Sleep mode: | after 5 minutes since ignition OFF |
| Ignition sensing: | DIN4 - Physical ignition signal |
Verticals
FTs devices can be used in the following verticals:
- Supply / Cold Chain
- Transportation
- Agricultural
- Business
- Construction
Use Cases
Standard tracking when permanent installation is required either on private vehicles or trucks.
Additional Documentation Manufacturer Documentation